Owners manual

Hood Protector Installation Procedures:
Peel red vinyl backing from the tape on the Hood Protector.
Align the Hood Protector lip over the edge of the hood as
shown in Figure #1 & #2, lining up the ends of the Hood
Protector with edge of the hood. The lip of the Hood Protector
should wrap around the front edge of the hood. Take care
not to exert pressure on the adhesive tape before you have
aligned the Hood Protector properly. Gently set into place on
the hood.
Apply 30 pounds of pressure per square inch to areas of the
parts opposite tape pads to ensure proper tape adhesion.
STEP 2:
A)
B)
C)
Figure #1
Hood Protector Placement
Figure #2
Hood Protector lip over edge of hood
IMPORTANT NOTE: Ambient Temperature – During
installation: the vehicle, the parts, and the tape need to be
between 60° and 110°F for proper adhesion. Vehicle surface
must also be wiped with alcohol to remove dirt and grease,
which may also affect adhesion. Failure to maintain proper
installation temperature and surface preparation may result in
the part not functioning correctly.
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
2