Owners manual

STEP 1 – PRIOR TO INSTALLATION
A)
B)
C)
Bushwacker only approves installing the Trail Armor according to these
written instructions with the hardware provided. WARNING: Failure to
install according to these instructions will invalidate the warranty. This
includes, but is not limited to using alternative installation methods,
hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar
products on the hardware or the fl ares.
Fit: Verify the fi t of the Trail Armor to vehicle. (Some fi ling, sanding, or
cutting may be necessary to ensure proper fi t).
Painting: (Optional) if paint is desired it must be done prior to
installing Trail Armor on vehicle. Clean outer surface with a good
grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL
REDUCER AS A DEGREASER. Wipe outer surface thoroughly with a
tack rag prior to paint. Application of plastic adhesion promoter for ABS
plastic as per your paint system manufacturer’s recommendations is
required. Paint Trail Armor using a high quality enamel, or polyurethane
automotive paint. If painting edge trim (not recommended), use a fl ex
additive.
Decals: Trail Armor may interfere with existing decals on vehicle. If you
wish, remove decals prior to installation of Trail Armor.
D)
4 pcs
Jeep
®
Trail Armor
®
Front Part #14007
Rev-2 10/16/2013
• Utility Knife
• #2 Phillips Driver Bit
• T15 Torx Bit
• T30 Torx Bit
• To claim a warranty, you must provide
Proof of Purchase.
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
TOOLS FOR EASY INSTALLATION:
Included in Hardware Kit:
1.
Set of 2
For complete fi tment info visit : www.bushwacker.com
Front Corners
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
1