Owners manual

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
Place driver side mount plate on top completed door
surround onto the vehicle and t the bracket over the
roll bar. Line up front hole to the front bracket door
surround. Repeat this step for both sides.
TIP: Make sure the rubber gasket at the top of the
windshield is correctly sealed against the front door
surround section. See photo for proper t and
check
that the factory foam seal is in place.
Position oor surround front bracket onto the vehicle
and t the bracket over the sport bar sport bar.
Fit top retention strap to door surround mount plate
hole located at rear. Locate the unused hole on the
back of door surround plate as shown. Note: There
is only one strap and it is installed on the driver side.
Starting at the front bracket hole insert door surround
knob into hole and tighten. Repeat step 14-15 for
other side.
Put the retention strap in place with the bolt through
the grommet as shown. Next, install the 2nd washer
and Nylock nut on top of the strap and tighten with
13mm socket wrench and 13mm wrench.
12 13
14 15
16
17