Owners manual

Bushwacker only approves installing the ares according to these
written instructions with the hardware provided. WARNING: Failure to
install according to these instructions will invalidate the warranty. This
includes, but is not limited to using alternative installation methods,
hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar
products on the hardware or the ares.
Fit: Verify the t of the ares to vehicle. (Some ling, sanding, or cutting
may be necessary to ensure proper t).
Painting: (Optional) if paint is desired it must be done prior to installing ares
on vehicle. Clean outer surface with a good grade degreaser. DO NOT USE
LACQUER THINNER OR ENAMEL REDUCER AS A DEGREASER. Wipe
outer surface thoroughly with a tack rag prior to paint. Application of plastic
adhesion promoter for ABS plastic as per your paint system manufacturer’s
recommendations is required. Paint ares using a high quality enamel, or
polyurethane automotive paint. If painting edge trim (not recommended), use
a ex additive.
Performance: Using larger Tires may increase the area required to turn
the vehicle. Some Tire/Rim combinations may require lowering bump
stops and or installing steering stops to prevent tire from contacting
are.
Exhaust System: Modications may be necessary to maintain a
minimum 4” clearance between ares and exhaust pipes. (Exhaust
gases should not vent directly onto ares)
Metal Protection: All exposed fasteners and bare metal should be
treated with rust resistant paint BEFORE installing ares. Spray inner
fender wells with undercoating AFTER are attachments have been
completed.
Decals: Flares may interfere with existing decals on vehicle. If you
wish, remove decals prior to installation of ares.
Care & Cleaning: Bushwacker fender ares are built to last; any
detergent you use to wash your vehicle is sufcient to clean the are.
Do not use any harsh abrasive detergents.
STEP 1 – PRIOR TO INSTALLATION
A)
B)
C)
D)
E)
F)
G)
H)
4325 HAMILTON MILL RD. BUFORD, GA 30518 1-800-241-7219 (USA AND CANADA) FAX 800-438-3788
35 pcs35 pcs 35 pcs
1 pc
Volkswagen Amarok
Pocket Style
®
Fender Flares
Set of 4
Set Part #171901-02 / #171905-02
Rev-3 02/07/2017
Included in Hardware Kit
4. 8.6.
9.
4 pcs 4 pcs 4 pcs 4 pcs
348 in
1. 7.2. 3.
T-45 Torx Bit
1/4” Ratchet
Needle Nose Pliers or Vice Grips
#2 Phillips Driver
Grease Pencil
Awl (optional)
TOOLS FOR EASY INSTALLATION:
To claim a warranty, you must provide
Proof of Purchase.
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
10.
1 pc
11.
For complete tment info visit : www.bushwacker.com
PLEASE READ: Dirt and debris can become lodged
between the fender ares and the vehicle’s fenders,
causing scratching and paint wear from vibration.
Lund International is not responsible for any damage,
and the installation of our fender ares is done with
the buyer’s understanding that this scratching and
paint wear may occur.

Summary of content (5 pages)