Owners manual

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
Bushwacker
®
only approves installing the ares according to these
written instructions with the hardware provided. WARNING: Failure to
install according to these instructions will invalidate the warranty. This
includes, but is not limited to using alternative installation methods,
hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar
products on the hardware or the ares.
Fit: Verify the t of the ares to vehicle. (Some ling, sanding, or
cutting may be necessary to ensure proper t).
Painting: (Optional) if paint is desired it must be done prior to installing
ares on vehicle. Clean outer surface with a good grade degreaser.
DO NOT USE LACQUER THINNER OR ENAMEL REDUCER AS A
DEGREASER. Wipe outer surface thoroughly with a tack rag prior to
paint. Application of plastic adhesion promoter for ABS plastic as per
your paint system manufacturer’s recommendations is required. Paint
ares using a high quality enamel, or polyurethane automotive paint. If
painting edge trim (not recommended), use a ex additive.
Performance: Using larger Tires may increase the area required to
turn the vehicle. Some Tire/Rim combinations may require lowering
bump stops and or installing steering stops to prevent tire from
contacting are.
Exhaust System: Modications may be necessary to maintain a
minimum 4” clearance between ares and exhaust pipes. (Exhaust
gases should not vent directly onto ares)
Metal Protection: All exposed fasteners and bare metal should be
treated with rust resistant paint BEFORE installing ares. Spray inner
fender wells with undercoating AFTER are attachments have been
completed.
Decals: Flares may interfere with existing decals on vehicle. If you
wish, remove decals prior to installation of ares.
Care & Cleaning: Bushwacker fender ares are built to last; any
detergent you use to wash your vehicle is sufcient to clean the are.
Do not use any harsh abrasive detergents.
STEP 1 – PRIOR TO INSTALLATION
A)
B)
C)
D)
E)
F)
G)
H)
34 pcs34 pcs 34 pcs 1 pc
6 pcs 14 pcs 8 pcs 2 pcs 2 pcs
2 pcs 1 pc 338 inches
Ford Pocket Style
®
Set Part #20942-02
Rev-4 07/05/2018
• Utility Knife
• #2 Phillips Driver
• 1/2” Wrench
• Socket Wrench
• 7/32” Socket
• 9/32” Socket
• 10mm Socket
• Grease Pencil
• To claim a warranty, you must provide
Proof of Purchase.
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
TOOLS FOR EASY INSTALLATION:
Included in Hardware Kit:
11. 12.
1. 2. 3. 5. 6.
8. 9. 10.
Set of 4
For complete tment info visit : www.bushwacker.com
13. 14.
Fender Flares
PLEASE READ: Dirt and debris can become lodged
between the fender ares and the vehicle’s fenders,
causing scratching and paint wear from vibration. Lund
International is not responsible for any damage, and the
installation of our fender ares is done with the buyer’s
understanding that this scratching and paint wear may
occur.
8 pcs
4.
2 pcs
7.
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.