Owners manual

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
Left Front
Flare
Right Front
Flare
Left Rear
Flare
Right Rear
Flare
Right Front
Inner Piece
Left Front
Inner Piece
Component List:
Put each Bolt/Washer combination through a pocket
hole in the are, Bolt head and Washer on the
outside.
Put a Washer (WA1-0012) on each Bolt (SW1-0067).
Pocket Hardware Installation:
A. Peel two to three inches of red vinyl backing away from Edge
Trim (GP1-0025) tape. Applying the adhesive side of the edge trim
to the inner side of the are, afx the edge trim to the top edge
o f t h e  a r e ( t h e p o r t i o n t h a t c o m e s i n c o n t a c t w i t h t h e v e h i c l e ) .
B. Press edge trim into place along the top edge of the are in one-foot
increments, pulling red vinyl backing free as you continue to work your
way around the top edge of the are. Trim ush with ends of are.
STEP 2 - EDGE TRIM INSTALLATION
1 2
If your ares already have the edge trim and pocket hardware installed, skip to Front Flare
Installation Step 4.