Owners manual

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
Front Flare Installation Procedures (Passenger’s Side):
Place a Nut (NU1-0019) over the end of each Bolt
and tighten, using a 1/2” wrench for the Nut and the
supplied Torx Bit (SW1-0052) for the Bolt. Repeat for
remaining pockets.
3
Remove six factory screws with a 7mm socket
wrench. Save screws for reinstallation.
Note: For Platinum Edition, after you remove the
factory are, there are additional screws to be
removed. These screws will be used for reinstallation.
4
Attach 3 “U”clips (CL1-0028) to the inner bracket as
shown.
5
Line up the holes in the inner piece with the three
uppermost factory holes. NOTE: Driver’s side inner
piece is marked with an “LR” and passenger’s side
inner piece is marked with an “RR”.
6
Using a 7mm socket wrench, reinstall the factory
screws through the inner piece.
7