Owners manual

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX 800-438-3788

Install supplied push retainer (RV1-P0001) into are

and through factory hole at rear of wheel well.

Completed rear are installation.

19 20

Using at end of supplied Edge Trim Tool (ET1-0002),

seat edge trim against are by inserting straight end

between edge trim and are at one end. Next, slide

around entire edge to the other end.

Using supplied Edge Trim Tool (ET1-0002), seat

edge trim against vehicle by hooking curved end

under edge trim at one end of are. Next, slide

around outer edge of are to the other end.

2221

Edge Trim Tool Procedures:

Start a supplied screw (SW1-0050) through the are

into the clip installed in Step19. Tighten all screws.

While holding are to vehicle, start supplied screws

(SW1-0058) through the four topmost mounting

holes in are and into the clips installed in Step 18.