Owners manual

STEP 1 – PRIOR TO INSTALLATION
A)
B)
C)
Bushwacker only approves installing the bumper protectors according
to these written instructions with the hardware provided. WARNING:
Failure to install according to these instructions will invalidate
the warranty. This includes, but is not limited to using alternative
installation methods, hardware, or materials. DO NOT USE: Loctite,
SuperGlue, or similar products on the bumper protector.
Fit: Verify the fi t of the bumper protector to vehicle. (Some fi ling,
sanding, or cutting may be necessary to ensure proper fi t).
Painting: (Optional) if paint is desired it must be done prior to
installing bumper protector on the vehicle clean outer surface
with a good grade degreaser. DO NOT USE LACQUER
THINNER OR ENAMEL REDUCER AS A DEGREASER. Wipe
outer surface thoroughly with a tack rag prior to paint. Paint
bumper protector using a high quality enamel, or polyurethane
automotive paint. (Application of a primer coat is optional) If
painting edge trim (not recommended), use a fl ex additive.
• Masking Tape
Toyota “OE” Style
®
Bumper Protector
Part #34018
Rev-3 7/25/2013
• To claim a warranty, you must provide
Proof of Purchase.
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
TOOLS FOR EASY INSTALLATION:
For complete fi tment info visit : www.bushwacker.com
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
1