Installation Manual

9 10
11
Center a supplied Tab (MT1-0002) over the marks
made in step 7, aligning edge of tab with inside edge
of fender lip (tab may extend over outside of fender).
Slide a supplied Clip (CL1-0022) over top two factory
holes. Clips may need to be adjusted to align with
holes in fl are. Note: Some vehicles with inner splash
sheild will need to remove factory fasteners in
indicated locations before installing the clips.
12
13
Slide a supplied Clip (CL1-0005) over lower four
tabs. Clips may need to be adjusted to align with
holes in fl are.
Reposition fl are on fender. Start a supplied Screw
(SW1-0058) through upper two hole locations and
through each Clip (CL1-0022) installed in step 11. If
needed, use awl to locate holes thru tabs installed
in step 10.
14
Start a supplied Screw (SW1-0050) through each of the
remaining holes and into each Clip (CL1-0005) installed
in step 12. If needed use awl to slide clips to meet hole
locations in fl are.
Center a supplied Tap (MT1-0002) over top two
factory holes.
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
4