Installation Manual

15
17
Fully tighten all screws starting with the newly installed
Screws (SW1-0058) in upper two hole locations while
pressing in on fl are to ensure it is snug against sheet
metal.
Edge Trim Tool Procedures:
Using fl at end of supplied Edge Trim Tool (ET1-0001),
seat edge trim against fl are by inserting straight end
between edge trim and fl are at one end. Next, slide
around entire edge to the other end.
Using supplied Edge Trim Tool (ET1-0001), seat
edge trim against vehicle by hooking curved end
under edge trim at one end of fl are. Next, slide
around outer edge of fl are to the other end.
16
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
5