Owners manual

Using a T-15 Torx bit, remove two factory screws in
muduguard at rear of front wheel well.
Front Flare Installation Procedures (Driver’s Side):
Turn front tire outward for easier installation.
To mount the fl are into position, hold the fl are 2-3”
inches below the top lip of the wheel well. Push in
and slide up to allow fl are to fully seat against the
wheel well opening.
Hold fl are in place and start supplied Screws (SW1-
0056) through two bottom rear holes in fl are and into
factory hole in rear of wheel well. Do not tighten.
4
6
While holding the fl are fi rmly in position, mark the
remainig fi ve hole locations with a grease pencil or
sharpie, using the holes in the fl are as a guide. Press
inward fi rmly on the fl are above each hole location
before making each mark, this will ensure proper fi t.
See next step.
Style Line
5
7
8
9
Hole locations to be marked.
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
3