Owners manual

2
1
3
5
4
11
13
12
Using a 3/32” drill bit, drill pilot holes at the marks
made in Step 9.
Install self-tapping screws (SW1-0066) into pilot holes
in the order indicated. TIGHTEN ALL SCREWS.
Locate fl are into position on vehicle. Install supplied
screw (SW1-0056) through two bottom rear holes in
fl are and into factory hole in rear of wheel well.
10
Remove the fl are. Using the marks made in step 7
as a guide, measure inward from the outside edge of
the fender to verify proper depth of original marked
location. Mark must be minium of 10mm in from
outside edge of fender, if short, adjust mark to 10mm.
Drill Mark
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
4