Owners manual

14 15
16 17
Using a T-15 Torx bit socket wrench, remove factory
installed screws. Discard screws.
Using a pry tool, remove factory retainers in bottom of
factory mudguard. Remove mudguard and discard.
Using a T-15 Torx bit socket wrench, remove the four
factory screws from the plastic wheel well piece.
Re-install two factory screws into wheel well liner.
1918
Using a grease pencil, mark fi ve locations using the
holes in the fl are as a guide.
Hold fl are fi rmly in place on fender. Start supplied
screw (SW1-0056) at bottom most screw locations
(shown). Do not tighten.
Rear Flare Installation Procedures (Driver’s Side):
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
5