Owners manual

20 21
22
Five hole locations to be marked. Remove the fl are. Using the marks made in step
18 as a guide, measure inward from the outside
edge of the fender to verify proper depth of original
marked location. Mark must be minimum of 22mm
in from outside edge of fender, if short, adjust marks
to 22mm.
Using a 3/32” drill bit, drill pilot holes at the marks
made in Step 20.
23
Install supplied screws (SW1-0056) into two lower
most holes.
24
Install supplied self-tapping screws (SW1-0066)
into pilot holes in the order indicated. TIGHTEN ALL
SCREWS
1
2
3
5
4
Drill Mark
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
6