Manualshelf

Installation Manual

ManualsBrandsBushwacker ManualsAutomotiveBushwacker 50907-02 Dodge Pocket Style Fender Flare , 2002 to 2008 Ram 1500, 2003 to 2009 Ram 2500, 2003 Ram 3500
12345
6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007
Put one pocket washer on a pocket screw and put
screw through a pocket hole in the fl are, screw head
on the outside.
Place a pocket nyloc nut over the end of the screw
and tighten, using a 1/2” wrench for the nut and the
supplied T45 torx bit for the screw.
Using the indents in the fl are pockets as a guide,
drill a 5/16” hole from the backside.
2
3
1
Front & Rear Flare Pocket Hardware Installation
Peel two to three inches of red vinyl backing away from edge trim tape.
Applying the adhesive side of the edge trim to the inner side of the fl are,
affi x the edge trim to the top edge of the fl are (the portion that comes in
contact with the vehicle).
Press edge trim into place along the top edge of the fl are in one-foot
increments, pulling red vinyl backing free as you continue to work your
way around the top edge of the fl are.
A)
B)
STEP 2 - EDGE TRIM INSTALLATION