Owners manual

Put each Bolt/Washer combination through a pocket
hole in the fl are, Bolt head and Washer on the
outside.
Put a Washer (WA1-0012) on each Bolt (SW1-0067).
At the inward, right angle curve in the fl are, cut a
notch in the edge trim so when you along the part,
the edge trim doesn’t stretch.
Start at the rearward end of the front fl are and work
toward the front. At the outward, right angle curve in
the fl are, cut a V out of the edge trim so when you
wrap around the part, the edge trim doesn’t bulge.
2
B
1
A
Pocket Hardware Installation:
A. Peel two to three inches of red vinyl backing away from Edge
Trim (GP1-0005) tape. Applying the adhesive side of the edge trim
to the inner side of the fl are, affi x the edge trim to the top edge
of the fl are (the portion that comes in contact with the vehicle ) .
B. Press edge trim into place along the top edge of the fl are
in one-foot increments, pulling red vinyl backing free as you
continue to work your way around the top edge of the fl are.
C. FRONT FLARES ONLY: The edge trim must be cut to prevent
bunching and stretching at the forward end of the part where the fl are
goes along the headlight. Refer to pictures A and B.
STEP 2 - EDGE TRIM INSTALLATION
If your fl ares already have the edge trim and pocket hardware installed, skip to Front Flare
Installation Step 4.
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
2