Owners manual

Place a Nut (NU1-0019) over the end of each Bolt and
tighten, using a 1/2” wrench for the Nut and the supplied
Torx Bit (SW1-0052) for the Bolt. Repeat for remaining
pockets.
2011-12 Models Only (Optional): If you encounter
a fi t problem, remove inner piece at bottom rear of
wheel well. Remove screws using an 8mm socket
Remove three factory installed screws with 8mm
socket wrench.
This vehicle has two types of front bumpers, metal
and plastic. Installation of this fl are is not affected by
which bumper the vehicle has. Pictured here is the
metal bumper.
(OPTIONAL) If an emblem interferes with proper
installation of fl are, remove it. Apply adhesive
remover to the emblem for ease of removal. Using a
plastic putty knife, carefully remove it, taking caution
not to scratch the paint.
76
3
4 5
Front Flare Installation Procedures (Passenger’s Side):
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
3