Owners manual

Bushwacker only approves installing the fl ares according to these
written instructions with the hardware provided. WARNING: Failure to
install according to these instructions will invalidate the warranty. This
includes, but is not limited to using alternative installation methods,
hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar
products on the hardware or the fl ares.
Fit: Verify the fi t of the fl ares to vehicle. (Some fi ling, sanding, or
cutting may be necessary to ensure proper fi t).
Painting: (Optional) if paint is desired it must be done prior to installing
fl ares on vehicle. Clean outer surface with a good grade degreaser.
DO NOT USE LACQUER THINNER OR ENAMEL REDUCER AS A
DEGREASER. Wipe outer surface thoroughly with a tack rag prior to
paint. Application of plastic adhesion promoter for ABS plastic as per
your paint system manufacturer’s recommendations is required. Paint
fl ares using a high quality enamel, or polyurethane automotive paint. If
painting edge trim (not recommended), use a fl ex additive.
Performance: Using larger Tires may increase the area required to
turn the vehicle. Some Tire/Rim combinations may require lowering
bump stops and or installing steering stops to prevent tire from
contacting fl are.
Exhaust System: Modifi cations may be necessary to maintain a
minimum 4” clearance between fl ares and exhaust pipes. (Exhaust
gases should not vent directly onto fl ares)
Metal Protection: All exposed fasteners and bare metal should be
treated with rust resistant paint BEFORE installing fl ares. Spray inner
fender wells with undercoating AFTER fl are attachments have been
completed.
Decals: Flares may interfere with existing decals on vehicle. If you
wish, remove decals prior to installation of fl ares.
Care & Cleaning: Bushwacker fender fl ares are built to last; any
detergent you use to wash your vehicle is suffi cient to clean the fl are.
Do not use any harsh abrasive detergents.
STEP 1 – PRIOR TO INSTALLATION
A)
B)
C)
D)
E)
F)
G)
H)
14 pcs 6 pcs
2 pcs
Nissan Pocket Style
®
Set Part #70909-02
Rev-1 4/18/2016
• Utility Knife
• Vinyl or Plastic Putty Knife
• Automotive Trim Pry Tool
• #2 Right Angle Ratcheting Screwdriver
• Socket Wrench
• 1/2” Socket
• Drill with 1/4” Bit
• To claim a warranty, you must provide
Proof of Purchase.
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
TOOLS FOR EASY INSTALLATION:
Included in Hardware Kit:
4. 7.
9.
2 pcs 6 pcs
1. 2. 3. 6.5.
8.
Set of 4
For complete fi tment info visit : www.bushwacker.com
10. 11.
Fender Flares
12.
2 pcs 6 pcs
13.
33 pcs
33 pcs
33 pcs 1 pc
318 inches
1 pc
PLEASE READ: Dirt and debris can become lodged
between the fender fl ares and the vehicle’s fenders,
causing scratching and paint wear from vibration.
Lund International is not responsible for any damage,
and the installation of our fender fl ares is done with
the buyer’s understanding that this scratching and
paint wear may occur.
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
1