Owners manual

If Factory Mudfl aps are installed, use a #2 Phillips
Screwdriver to remove them.
14
Rear Flare Installation Procedures:
If Factory Flares are installed, use a #2 Phillips
Screwdriver to remove them. If no Factory Flare is
installed, go to Step 17.
15
Install a supplied screw (SW1-0056) into the hole in
the fl are and into the bracket. Tighten all screws.
Install a supplied push retainer (RV1-P001) into the
hole drilled in the previous step.
Installation complete.
Push in on the front of the fl are. Using a drill with a
1/4” bit, use the hole in the fl are as a guide and drill
a hole into the wheel well.
10
12 13
11
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
4