Instructions / Assembly

www.buyersproducts.com
Phone [phone]
Fax [phone]
Toolbox Mounting Instructions
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions.
Any product which has been altered, including modification, mis-
use, accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of Buyers
Products Co. under this warranty is limited to repairing or replacing any
part or parts which are returned, prepaid, and are found to be defective
by Buyers Products Co. Authorization from Buyers Products Co. must
be obtained before returning any part. No charges for transportation
or labor performed on Buyers’ products will be allowed under this
warranty.
3000105 Rev. D
Please read these instructions and warnings before installation.
PART NO. QT Y. DESCRIPTION
1701005 One Pair of 18" x 18" Structural Welded Brackets
1701010 One Pair of 18" x 24" Structural Welded Brackets
1701015 One Pair of 24" x 24" Structural Welded Brackets
1701005B One Pair of 18" x 18" Structural Bolted Brackets
1701010B One Pair of 18" x 24" Structural Bolted Brackets
1701006 One Pair of 18" x 18"Formed Welded Brackets
1701011 One Pair of 18" x 24" Formed Welded Brackets
1701016 One Pair of 24" x 24" Formed Welded Brackets
1701006B One Pair of 18" x 18" Formed Bolted Brackets
1701011B One Pair of 18" x 24" Formed Bolted Brackets
1701030 One Pair of 18" x 18" Aluminum Brackets
1701040 One Pair of 24" x 24" Aluminum Brackets
1701031 One Pair of 18" x 18" Stainless Brackets
1701041 One Pair of 18" x 24" Stainless Brackets
Outter Flat
Surface to be
Mounted to
Vehicle Frame
Inner Flat Surface
to be Mounted to
Toolbox
Support Box
Along Entire
Bracket
Truck Frame
1701005
1701010
1701015
DANGER
Do not use this toolbox for the storage or transportation
of flammables, explosives, hazardous waste or materials
such as gasoline, solvents, gun powder, dynamite, pro-
pane tanks, acetylene tanks or cutting torches. This tool-
box is only intended and safe for use in storing and trans-
porting small tools and equipment and/or other materials.
WARNING
1. If the proper mounting brackets are not used, the tool-
box could drop off the vehicle while it is moving and cause
personal injury and/or property damage.
2. Mounting your toolbox through the top, back or sides
without bottom support will significantly reduce the
capacity and possibly the life of the toolbox.
3. Prior to any welding or drilling holes in a vehicle frame,
check for location of fuel tanks, fuel lines, brake lines or
electrical wires.
4. If welding is to be done on a vehicle frame in the
mounting of this toolbox, disconnect the cables from the
battery to prevent shorting of electrical components on
the vehicle.
5. Always wear protective eyewear when drilling, welding
or checking the underside of a vehicle.
To properly support your Underbody Toolbox, we recommend the
use of bottom support mounting brackets. These brackets should
be placed so that each end of the toolbox is supported by the full
width of the mounting bracket. To prevent rust, touch-up drilled
holes with aerosol paint. To prevent water leaks, apply silicone
sealant all around each fastener after installation.