Owner manual

ManualsBrandsBuyers ManualsFor the car1503005

Quality since 1946

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • buyersproducts.com

Steel Service Body LADDER RACK

Model 1503005

2 Front Posts

2 Rear Posts

4 Siderails

1 Rear Cross Bar

1 Blank Cross Bar

1 Cross Bar with clamp

1 Cross Bar Ends

6 Clamps

5 3/8”-16 x 5/8” Hex Head Bolt

36 3/8”-16 x 1” Carriage Bolt

36 3/8”-Hex Nuts

36 3/8”-Lock Washer

36 3/8”-Flat Washer

2 Locking Pins

NOTE: Front Posts have welded NUTS

Rear Posts have through holes

QTY. DESCRIPTION

Bill of Materials

CARRIAGE

BOLT

LOCKING

9/16”

WRENCH

LOCK

WASHER

FLAT

WASHER

5/8” HEX

HEAD SET BOLT

NUT

CLAMP

Tools Needed for Assembly

MEASURING

TAPE

• • •• • • • •

CAREFULLY INSPECT

AREAS TO BE

DRILLED ON

VEHICLE PRIOR TO

DRILLING ANY HOLES

FOR POSSIBLE

HAZARDS

AND OBSTRUCTIONS

READ ALL INSTRUCTIONS

BEFORE STARTING ANY

INSTALLATION

ELECTRIC DRILL

(with 13/32” or 3/8” Bit)

Installation Instructions

Summary of content (4 pages)

PAGE 1
Quality since 1946 9049 Tyler Blvd. • Mentor, Ohio 44060 Phone (440) 974-8888 • Fax (440) 974-0165 Toll-Free Fax 800-841-8003 • buyersproducts.com Installation Instructions Steel Service Body LADDER RACK Model 1503005 Bill of Materials QTY.
PAGE 2
9049 Tyler Blvd. • Mentor, Ohio 44060 Phone (440) 974-8888 • Fax (440) 974-0165 Toll-Free Fax 800-841-8003 • buyersproducts.com Quality since 1946 Figure 1 RAIL ROSS TH ENDS) C R A O RE ES ON B OL (3/8” H SIDERAILS LEFT REAR POST RIGHT REAR POST K BAR BLAN th AR wi B K N BLA NOTE: Front Posts have welded NUTS Rear Posts have through HOLES P CLAM RIGHT FRONT POST Assembly 1.
PAGE 3
9049 Tyler Blvd. • Mentor, Ohio 44060 Phone (440) 974-8888 • Fax (440) 974-0165 Toll-Free Fax 800-841-8003 • buyersproducts.com Quality since 1946 4. After rear posts are secured and tightened with a 9/16” wrench, identify the Rear bar (telescoping tube with 3/8” pre-drilled holes on either end), and insert into left & right rear post making sure: 4 A. Tubes are compatible and match. B. Pre-drilled holes match those on corner posts C. Welded nuts face down 5.
PAGE 4
9049 Tyler Blvd. • Mentor, Ohio 44060 Phone (440) 974-8888 • Fax (440) 974-0165 Toll-Free Fax 800-841-8003 • buyersproducts.com Quality since 1946 11. Repeat on opposite side. 12b 11 12. Install Cross Bar with Clamp in the front of the rack by inserting Crossbar end and telescoping tubes until they are extended to secure to side rails. Secure the Cross Bar end with a clamp and 4 Carriage Bolts, 4 lock washers, 4 flat washers and 4 nuts. 12a 13.