Owner manual

Quality since 1946Quality since 1946
5
Tools Required
•1/2" drill bit
•3/4" socket
•3/4" wrench
•9/16" socket
•9/16" wrench
•Torque wrench
1. Insert 1/2" screws with 1/4" plate down
through 1" holes at end of frame. Fasten brackets
to frame as shown with 1/2" washers and lock
nuts. Leave nuts loose at this time.
2. Install middle section as shown. Use bolting
locations indicated. Attach middle section using
3/8" screws, washers and lock nuts. NOTE: Be
sure to use four holes to bolt side brackets to
middle section. Leave nuts finger tight at this
time. Some spare tire carriers may need to be
modified if the receiver hits tire.
3. Using the most farthest holes in brackets as
a guide, drill 1/2" holes in frame.
Dodge Full Size Pickups, 1971-1993
4. Insert 1/2" screws with 1/4" plates down
through frame and brackets. Install 1/2" washers
and lock nuts.
5. Tighten nuts in the following order: First
torque 3/8" nuts to 40 ft-lb. Then torque 1/2" nuts
to 70 ft-lb.
6. Install plastic plugs into 3/8" holes in middle
section.
1 3004980 1 Middle Section
2 3004908 1 Side Bracket
3 3004909 1 Side Bracket
4 FCS038016125 8 Screw, HHC-3/8-16 x 1.25 Gr 5 Zn
5 FWF038081006 16 Washer, Flat 3/8 SAE Zn
6 FNE038016044 8 Nut, Nylock 3/8-16 x 7/16 Zn
7 3004907 2 Bolt Plate, 1/4"
8 3001384 2 Screw, Hex Cap 1/2-13 x 2" Gr 5 Zn
9 FWF050106010 2 Washer, Flat 1/2" SAE Zn
10 FNE050013053 2 Nut, Nylock 1/2-13 Zn
11 3005078 2 Plug, 7/16" dia. Poly
ITEM PART NO. QTY. DESCRIPTION
Bill of Materials