MAIN PARTS NAME INSTALLATION REQUIREMENT BV-RH-01, RS-030-TS: 1. Do not install the Range hood where there are many doors or windows in other to avoid to effecting the exhaust efficiency of the hood caused by air convection. Shutter 2. Install the Range hood right above the hob. The recommended distance between the hob and the lower edge of the cooker hood is minimum 650mm and maximum 700mm. 3.
How to install po Wood Screw A Exhaust pipe Shutter Step 1: According to the size of the holes. Drill 2 holes in level in the wall with 8mm in diameter and in depth. Press the 2 expanding tube provided into the holes. Tighten the 2 wood screws of which are supplied together with the hood to the expanding tube, make sure it is strongly fixed and can not move. Step 2: Unscrew the hook with a screwdriver, Then adjust the high of the hook to over top the hood body.
If applicable, test the damper blade to ensure it rotates up and down freely. If applicable, connect the duct work to the range the joints with duct tape to ensure an airtight fit. Install on the wall Lift the range hood{A) up to the wall to determine its final position. Mark the location of the 2 keyhole mounting slots(4) and 2 keyhole mounting slots(5) on the wall. Set the range hood aside on a protective surface. Drill four pilot holes in the locations that you marked.
OPERATING INSTRUCTION How to use the 3 speed touch control without Press button A to turn on the light. Press it again to turn off the light. B: Press button B, the fan runs at high speed, press it again to turn off the fan, C: Press button C, the fan runs at medium speed, press it again to turn off the fan. D: Press button D, the fan runs at low speed, press it again to turn off the fan.
TO REPLACE LIGHT BULB CAUTION: LAMP UNIT MAY BE HOT! WAIT UNTIL THE UNITS COOL. AND USE THE SAME TYPE LIGHT BULB! Caution: LED lamp can not replace a new bulb, just can replace anew LED lamp. Make sure all the control switches are off, and the cooker hood is unplugged! Please follow the below instructions: 1. Take out the filters, and cut off the wire connection of the lamp. 2. Press the spring according to the arrow direction, then you can take off the lamp unit. 3.
TROUBLE SHOOTINGS CAUTION: Disconnect the power supply before servicing. To replace the bulb should be undertaken by a STATUS CAUSE AND METHOD OF REPAIRING TOOL qualified electrician ora The power "7 type competent person. supply is If the power supply is damaged, please call the technician Screwdriver damaged | "storekeeper Sharp Pincers a) Remove the vane guard and rotate the vane by hand, If the vane cannot move smoothly, the core or bearings The lamp of the motor may be damaged.