PG6505-M0 rev 09/07 Gas Engine Pumps Instruction Manual MODELS: PG5505 & PG6505 SFA Companies 10939 N. Pomona Ave. Kansas City, MO 64153 Tel: 888-332-6419 * Fax: 816-891-6599 E-mail: sales@bvahydraulics.com Website: www.bvahydraulics.com ! This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Save these instructions. For your safety, read and understand the information contained within. The owner and operator shall have an understanding of this product and safe operating procedures before attempting to use this product. Instructions and safety information shall be conveyed in operator's native language before use of this product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with the use and misuse of the product.
Gas Engine Fuel Cap Engine Starter Grip Oil Dipstick Cap Frame Control Valve Hydraulic Oil Cap (not shown, on reservoir) Control Valve Lever Hydraulic Oil Reservoir Oil Output Ports 3/8"-18NPTF Drain Plug Carry Handle Figure 1 - Model PG5505 Components Oil Dipstick Cap Gas Engine Fuel Cap Engine Starter Grip Frame Control Valve Control Valve Lever Hydraulic Oil Reservoir Oil Output Ports 3/8"-18NPTF Hydraulic Oil Cap Drain Plug Carry Handle Figure 2 - Model PG6505 Components 3
! ! This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. DANGER There are hazards associated with the use of this equipment which can only be avoided by reading, understanding and following all the printed materials provided by the manufacturer of the gasoline engine which drives this hydraulic pump.
BEFORE USE 1. Most malfunctions in new equipment are the result of improper operation and/or improper set-up assembly. 2. Visually inspect all components for shipping damage. Do not use if any damage is found. Note: Gas Pump is shipped without hydraulic oil. Add oil before operating. 3. Familiarize yourself with the specifications and illustrations in this owners manual. Know your pump, its limitations and how it operates before attempting to use.
OPERATION ! ALWAYS monitor pressure, load or position using suitable equipment. Pressure may be monitored by means of an optional manifold and gauge (contact BVA Hydraulics). Load may be monitored by means of a load cell and digital indicator. Correct application position can only be determined by the operator of the equipment. 1. Check all system fittings and connections to be sure they are tight and leak free. 2. Check the engine oil level. Please refer to engine owner's manual. 3.
MAINTENANCE 1. For gas engine, please refer to engine owner's manual. 2. Inspect hoses and connections daily. Replace damaged components immediately with BVA Hydraulics replacement parts only. 3. Tighten connections as needed. Use non-hardening pipe thread compound when servicing connections. 4. Check hydraulic oil level every 40 hours of operation. Add hydraulic oil if necessary. 5. Completely change the hydraulic oil every 300 hours of operation.
TROUBLESHOOTING GUIDE The following information is intended as an aid in determining if problem exists. Pumps should be repaired only by authorized BVA Service Center. For repair service, contact service center in your area.
LIMITED LIFETIME WARRANTY BVA Hydraulics®, represented in the United States by SFA Companies [“SFA”] warrants this product to be free from defects in material and workmanship for the life of the product as long as the original purchaser owns the product.
Gas Engine Pump Service Parts MODEL: PG5505 (Honda Engine) SFA Companies 10939 N. Pomona Ave. Kansas City, MO 64153 Tel: 888-332-6419 * Fax: 816-891-6599 E-mail: sales@bvahydraulics.com Website: www.bvahydraulics.com Note: Not all components of the pump are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence.
Gas Engine Pump Service Parts MODEL: PG6505 (Briggs & Stratton Engine) SFA Companies 10939 N. Pomona Ave. Kansas City, MO 64153 Tel: 888-332-6419 * Fax: 816-891-6599 E-mail: sales@bvahydraulics.com Website: www.bvahydraulics.com Note: Not all components of the pump are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence.
SFA Companies 10939 N. Pomona Ave. Kansas City, MO 64153 Tel: 888-332-6419 E-mail: sales@bvahydraulics.
