User's Manual
Table Of Contents
- Introduction
- Contacting BW Technologies
- Safety Information - Read First
- Getting Started
- The Personnel Alert Base Station
- Installation
- MODBUS Wiring and Configuration
- Baud Rate and Parity Configuration
- Setting the Dip Switch Addresses
- Alarm Relay Contact Wiring and Configuration
- Wiring DC Power
- Testing Manual Alarms
- Radio Frequency (RF) Optimization
- Setting the Badge ID
- Area System Planning
- Alarms (TBD)
- Maintenance
- Troubleshooting (TBD)
- Replacement Parts and Accessories
- Specifications
Personnel Alert: Base Station
Safety Information - Read First
a Cautions
⇒
Do not use the base station if it is damaged. Inspect the case before using the base station. Look for cracks, missing
metals, and plastics. If the base station is damaged or parts are missing, contact
BW Technologies immediately.
⇒
Make sure the cover is properly fastened before operating the base station.
⇒
Do not expose the base station to electrical shock and/or severe continuous mechanical shock.
⇒
Do not attempt to disassemble, adjust, or service the base station unless instructions for that procedure are provided
in the manual and /or that part is listed as a replacement part. Refer to
Replacement Parts and Accessories.
⇒
Do not allow liquids to condense and/or use high power spray on the base station.
⇒
The Personnel Alert Base Station is only certified with the supplied 2 dBi dipole antenna. Do not substitute this
antenna with another. Refer to
Replacement Parts and Accessories.
⇒
When installing cables, ensure they are protected from possible damage. Secure the cable(s) in place and fasten any
excess.
⇒
Do not attach system components that do not meet specified criteria, such as alarms, relays, cabling, etc.
⇒
The base station warranty will be void if the unit is disassembled, adjusted, or serviced by non-BW Technologies
personnel.
3