User's Manual
Table Of Contents
- Introduction
- Contacting BW Technologies
- Safety Information - Read First
- Getting Started
- The Personnel Alert Base Station
- Installation
- MODBUS Wiring and Configuration
- Baud Rate and Parity Configuration
- Setting the Dip Switch Addresses
- Alarm Relay Contact Wiring and Configuration
- Wiring DC Power
- Testing Manual Alarms
- Radio Frequency (RF) Optimization
- Setting the Badge ID
- Area System Planning
- Alarms (TBD)
- Maintenance
- Troubleshooting (TBD)
- Replacement Parts and Accessories
- Specifications
Personnel Alert: Base Station
The Personnel Alert Base Station
Control Bay
Each base station maintains a control bay that consists of an
LCD screen and a low light sensor to provide information to
monitoring personnel.
Table 3. Control Bay
Item Function
1
Liquid crystal display (LCD)
2
Low-light sensor
3
Faceplate security screw
The control bay does not have any manual functions and is
used to provide information only. To set parameters and
configurations for badges and monitoring coverage areas,
refer to
Area System Planning and Setting the Badge IDs.
Figure 2. Control Bay
7