User's Manual
Table Of Contents
- Introduction
- Contacting BW Technologies
- Safety Information - Read First
- Getting Started
- The Personnel Alert Base Station
- Installation
- MODBUS Wiring and Configuration
- Baud Rate and Parity Configuration
- Setting the Dip Switch Addresses
- Alarm Relay Contact Wiring and Configuration
- Wiring DC Power
- Testing Manual Alarms
- Radio Frequency (RF) Optimization
- Setting the Badge ID
- Area System Planning
- Alarms (TBD)
- Maintenance
- Troubleshooting (TBD)
- Replacement Parts and Accessories
- Specifications
Personnel Alert: Base Station
Installation
Radio Board
The radio board is positioned below the main board in the
base station. It provides the
• 2-wire and 6-wire screw down connectors,
• S1 and S2 channel hopping dip switches,
• Reduced Range (RR) radio jumper, and
• transmit and receive rotary switches.
Table 7. Radio Board
Item Function
1
Relay contact dip switch (S1)
2
Cable connector to main board
3
Channel hopping dip switch (S2)
4
Reduced Range (RR) jumper
5
6-wire alarm relay connectors
6
2-wire 24V DC power supply connector
7
Transmitter rotary switch (TX Gain)
8
Receiver rotary switch (RX Gain)
Figure 6. Radio Board
The radio board is used to
11