User's Manual

Personnel Alert: Base Station
User Manual
Setting-up the Badge IDs
Read the following procedures prior to accessing the badge
ID set-up screen. To set-up the badge ID numbers, complete
the following:
Note
The badge IDs should be set-up prior to the
employee entering the coverage area to ensure
proper safety.
The NO SIGNAL icon displays during the setup.
Receiving broadcasts are not required during the
set-up process. The base station will automatically
identify any badge that has been set-up.
1. The badge set-up can only be accessed during the
start-up process. If required, deactivate the badge.
2. Press C and continue to hold until the badge ID
setup screen displays and the side LED flashes
once (approximately 10 seconds).
The badge emits the audible alarm, flashes, and
vibrates the same as during normal start-up. The
audible alarm, flashes, and vibrating will stop for 3
seconds. Continue to hold the C button.
When the side LED lights, release and immediately press C
again.
Area System Planning
Base stations can be configured to operate as single or
multiple notification systems, depending upon the
• area of the zones,
• complexity of the area (buildings / obstructions),
• indoor and/or outdoor installations,
• alarm/emergency response procedures,
• number of badges, and
• the functional requirements of the badges.
The base station system can be configured for individual and
unique requirements.
Note
Area system planning and configurations must be
performed by qualified personnel only.
30