User's Manual
Table Of Contents
- Introduction
- Contacting BW Technologies
- Safety Information - Read First
- Getting Started
- The Personnel Alert Base Station
- Installation
- MODBUS Wiring and Configuration
- Baud Rate and Parity Configuration
- Setting the Dip Switch Addresses
- Alarm Relay Contact Wiring and Configuration
- Wiring DC Power
- Testing Manual Alarms
- Radio Frequency (RF) Optimization
- Setting the Badge ID
- Area System Planning
- Alarms (TBD)
- Maintenance
- Troubleshooting (TBD)
- Replacement Parts and Accessories
- Specifications
Personnel Alert: Base Station
Maintenance
Maintenance
The Personnel Alert Base Station is designed to provide
years of service with only regular care and minimal
maintenance. At regular intervals inspect the instrument and
check that it is operating normally.
Antenna: Replace the bent or damaged antenna.
Cables: Inspect cables to ensure they are properly
connected and in good repair.
35