User's Manual
Table Of Contents
- Introduction
- Contacting BW Technologies
- Safety Information - Read First
- Getting Started
- The Personnel Alert Base Station
- Installation
- MODBUS Wiring and Configuration
- Baud Rate and Parity Configuration
- Setting the Dip Switch Addresses
- Alarm Relay Contact Wiring and Configuration
- Wiring DC Power
- Testing Manual Alarms
- Radio Frequency (RF) Optimization
- Setting the Badge ID
- Area System Planning
- Alarms (TBD)
- Maintenance
- Troubleshooting (TBD)
- Replacement Parts and Accessories
- Specifications
Personnel Alert: Base Station
User Manual
Troubleshooting (TBD)
If you encounter a problem, follow the solutions listed in the table below. If you are unable to correct the problem, contact BW
Technologies.
Table 19. Troubleshooting Tips
Problem Possible Cause Solution
→ →
→ →
There is no transmission to the Badge.
→ →
There is no signal from the controller.
→ →
→ →
→ →
→ →
→ →
36