User's Manual
Table Of Contents
- Introduction
- Contacting BW Technologies
- Safety Information - Read First
- Getting Started
- The Personnel Alert Base Station
- Installation
- MODBUS Wiring and Configuration
- Baud Rate and Parity Configuration
- Setting the Dip Switch Addresses
- Alarm Relay Contact Wiring and Configuration
- Wiring DC Power
- Testing Manual Alarms
- Radio Frequency (RF) Optimization
- Setting the Badge ID
- Area System Planning
- Alarms (TBD)
- Maintenance
- Troubleshooting (TBD)
- Replacement Parts and Accessories
- Specifications
List of Figures
Figure Title Page
Figure 1. Personnel Alert Base Station ...................................................................................6
Figure 2. Control Bay............................................................................................................... 7
Figure 3. Base Display Elements ............................................................................................8
Figure 4. Badge Display Elements.......................................................................................... 9
Figure 5. Main Board.............................................................................................................10
Figure 6. Radio Board ...........................................................................................................11
Figure 7. Outline Drawing of Base Station............................................................................13
Figure 8. Base Station Installation Front View ......................................................................14
Figure 9. Cable and Wire Installation ....................................................................................15
Figure 10. Power, Ground, and Relay Wiring .......................................................................16
Figure 11. Wiring Installation.................................................................................................17
Figure 10. MODBUS Wiring on Main Board..........................................................................18
Figure 11. S1 and S2 Dip Switches for MODBUS Configuration..........................................20
Figure 15. Alarm Relay Contact Wiring.................................................................................22
Figure 16. Alarm Relay Contact on Radio Board..................................................................23
Figure 17. Transmit Rotary Switch Maximum Power Setting................................................27
Figure 18. Receiver Rotary Switch Maximum Sensitivity......................................................28
Figure 19. Honeycomb Pattern .............................................................................................32
Figure 20. Base Station Broadcast Coverage.......................................................................33
v