Instructions / Assembly

Adjustable Wrench Allen key

Philips Screwdriver

INSTALLATION MANUAL Tools You will need

Wall Mounted Basin Faucet Installation

Teflon Tape

2.Use the tape on pipe threads, connected to the

main body (A) cold and hot as required inlet pipe

and outlet pipe, checking the leakage before

fixing the main body in the embedded hole (keep

the horizontal and vertical). And assembling the

protection plastic cover (B).

3. Remove the prastic cover (D) and then

put the base through the cartridge cover(C),

use Alleny key(E) and the hexagon socket

screw to assemble the handle(F) to the

body, and then put on the decorative

button(G).

4. Wrap nylon tape around the screw

thread at the end of thread pipe, and then

tighten the thread pipe(I) to the water pipe.

5. Fix the spout (K) to the position block and the

thread pipe, and then use the Allen key(E) to tight

the spout with the thread pipe.

6.Finished.

Before the Installation

1.Check the package and confirm all parts are included. If any part is missing or damaged, please contact

us.

2.Do not disassemble the main body,as it has been installed & commissioned correctly & precisely before

leaving the factory.

3.Shut off the main water supply prior to beginning installation.

4.Do flush the water supply lines to remove any dirt and debris before installation (IMPORTANT) .

5.Make sure to connect the hot/cold inlet pipe correctly.If standing in front,connect hot water pipe to the left

and cold water pipe to the right.

6.After the installation,check for leaks and make sure every joint is safely sealed.

Cleaning and Maintenance

1.Rinse with clean water and dry with a soft cloth.

2.Do not use any detergent,acid,polisher,abrasives,or harsh cleaners.

3.Do not use cloth with a coarse surface.

MAX:Ø32

1.Holes size for the built in control valve:

175*75*(50-55), the depth between the

bottom of the control valve to the tile surface

is 50-55mm.