Instructions / Assembly

ManualsBrandsBWE ManualsBathSingle-Handle 6-Spray Round High Pressure Shower Faucet Detachable 6 in. Shower Head in Matte Black (Valve Included)

Adjustable Wrench Allen key

Philips Screwdriver

INSTALLATION MANUAL Tools You will need

Wall Mounted Bathtub Faucet Installation

Teflon Tape

4.Turn the water on for 1 minute to flush

any debris. Apply Teflon tape (H) to the

threaded tail pipe and install the shower

hose (I) into the outlet on the wall,Then

connect the top shower (P) to the spout.

5.Apply Teflon tape (H) to the threaded

end,the fix the cover plate (J) onto the wall

supply holder (K) and screw the wall

supply holder (K) into the hand shower

outlet.

6.Add rubber washers (L) at both ends of

the shower hose (M).Connect shower

hose (M) to the wall supply holder (K) and

hand shower (N).Then, place the hand

shower (N) to the wall supply holder (K).

Before the Installation

1.Check the package and confirm all parts are included. If any part is missing or damaged, please contact

us.

2.Do not disassemble the main body,as it has been installed & commissioned correctly & precisely before

leaving the factory.

3.Shut off the main water supply prior to beginning installation.

4.Do flush the water supply lines to remove any dirt and debris before installation (IMPORTANT) .

5.Make sure to connect the hot/cold inlet pipe correctly.If standing in front,connect hot water pipe to the left

and cold water pipe to the right.

6.After the installation,check for leaks and make sure every joint is safely sealed.

Cleaning and Maintenance

1.Rinse with clean water and dry with a soft cloth.

2.Do not use any detergent,acid,polisher,abrasives,or harsh cleaners.

3.Do not use cloth with a coarse surface.

3.Remove the protective cover when the finished

wall is completed and install the escutcheon (B) to

the valve (A) and press it against the finished

wall.Then, install the handle (C) and diverter knob

(D),tighten set screws (E) with Allen key (F),and

put on the indication buttons (G).

hot water inlet

cold water inlet

outlet 1

outlet 2

outlet 3

2(1).According to the site condition and the

installation size requirement to set up the pipe

line.(2).Connect the plastic box to the pipe,put

the plastic box on the hole,then adjusted the

levels(the bubble on the middle of the

leveller).(3).Make the positioning holes.

1.Acoording to the site condition and the

installation size requirement and to make a

hole,the hold size is 180mm(length)*130mm

(width)*65-75mm(deep).