User Manual

NÜO Flux Manual
Installation
8
NÜO FLUX
Installation on plasterboard walls
2. Installation on plasterboard walls 10 to 22 mm thick:
1) Using a level, make a hole in the wall for
the rear case measuring 82 x 82 mm. Do not
forget to pass the power and communication
cables through.
2) Place the case in the hole and screw the
pressure tabs to x the case to the wall. These
tabs apply pressure against the wall as the
screws are turned.
82
82
Plasterboard Plasterboard
Place the magnet at the top. This magnet
will work as a tamper.
Recommended height for installation is
between 1.2 and 1.5 m.
3) Remove the NÜO FLUX reader front glass
panel using the suction cup supplied. Place
the suction cup in a corner for ease of oper-
ation.
4) Pass the cable through the opening made
and attach the reader to the rear case using
the screws supplied as shown in the drawing.
Finally, replace the front glass panel.: