Owners Manual

BYD AUTO F3 OWNER’S MANUAL
180
After filling the washer fluid
reservoir, ensure that the funnel is put
back in its original position.
NOTICE
Do not use engine antifreeze or any
other substitutes because it may
damage you vehicle’s paint.
Replacing light bulbs
The following illustrations show how
to take bulbs off. When replacing a
bulb, make sure the ignition switch
and light switch are turned off. Use
bulbs with the wattage ratings given
in the table.
Parking and rear position light
(parking light, rear turn-light, and
braking light of F3-R) are composed
of a LED set. If the blown LED
number does not comply with the
local rules, send your vehicle to BYD
AUTO service station for removing
bulbs.
CAUTION
● To prevent burns, do not
replace the light bulbs while
they are hot.
● Halogen bulbs have pressurized
gas inside and require special
handling. They can burst or
shatter if scratched or dropped.
Hold a bulb only by its plastic
or metal case. Do not touch the
glass part of a bulb with bare
hands.
The inside of the lens of exterior
lights such as headlights may
temporarily fog up when the lens
becomes wets in the rain or after your
car is washed. This is not a problem.
Fogging is caused by the temperature
difference between the outside and
inside of the lens, just like the
windshield fogs up in the rain.
However, if there is a large drop of
water on the inside of the lens, or if
there is water pooled inside the light,
contact your BYD AUTO service
station.
NOTICE
Use a bulb of the listed type only.