Owners Manual

BYDAUTO F3 OWNER’S MANUAL
58
The automatic light control sensor is
on the top of the instrument panel at
driver’s side.
Do not place anything on the
instrument panel, and do not affix
anything on windshield to block this
sensor.
When you turn the ignition key from
“ON” to the “ACC” or “LCOK”, or
pull the key out with headlights
switch on, the headlights will go off.
If you want to turn on the headlights
again, turn the ignition key to “ACC”
or “ON”. If your vehicle will be
parked for no less than one week,
make sure the headlight switch is off.
NOTICE
To prevent the battery from being
discharged, do not leave the lights
on for a long period when the engine
is not running.
High-low beams: For high beams,
push the lever to position 1. For low
beams, push the lever to position 2.
Pull the lever to position 3 for high
beams. The indicator light (blue light)
for on the instrument panel the
headlight high beam will tell you that
the high beams are on.
Flashing the high beam of
headlights (position 3)
Pull the lever all the way back. The
flashing high beam of headlights will
turn off when you release the lever.
You can flash the high beam
headlights with the knob turned to
“off”.
Turn signal lights
To signal a turn, push the left
multi-function switch up or down to
position 1.
The key must be in the “ON”
position.
The lever automatically returns after
you make a turn, but you may have to
return it by hand after you change a
lane.
To signal a lane change, move the
lever up or down to the pressure point