Owner’s Manual

BYD AUTO F6 OWNER’S MANUAL
66
Once the station is stored, you can press the
left or right side of preset bar to listen to it.
The frequency will be lost if the battery is
discharged or disconnected, or the radio
fuse is taken out.
AUTO SELECT & SAVE (Hold
SCAN)—Press SCAN for 2 seconds, the
system will search the station and store it on
FM1, FM2, FM3 or AM1, AM2. To activate
it, long press the SCAN button. Then the
SCAN is displayed in flashing. The preset
bar (1～6) can store 12 stations on AM and
18 stations on FM, then you can use the
preset bar (1 ～ 6) to choose the preset
station.
If you don‘t like the frequency AUTO
SELECT & SAVE has stored, you can store
other frequency on the preset bars. Use the
TUNE, SEEK or SCAN function to search
desired frequency and store the frequency to
preset bars as described above.
Audio adjustment
The BAS, TRE, BAL and FAD can be
adjusted.
Press AUDIO, choose the desired mode.
Press the AUDIO repeatedly, the mode can
change in the order of BAS to TRE to BAL
to FAD. When changing the mode, the
related mode name will be displayed.
Volume balance (L-R/F-R) — these two
modes adjust the strength of the sound
coming from each speaker. BALANCE
adjusts the left to right strength while the
FADER adjusts the front to rear strength.
Press AUDIO, to choose BALANCE OR
FADER mode. Rotate the volume knob, the
BALANCE OR FADER can be adjusted to
desired degree. The displayed number is the
current setting. It will display‖0‖ when the
volume reaches the center of range.
Alt/Bass—Use these modes to choose the
desired tone. Press AUDIO, to choose TRE
or BAS mode. Rotate volume knob to
desired mode. The displayed number is the
current set.
It will display the ―0‖ when tune level
reaches the center of range. Several seconds
after you stop to operate the volume knob,
the system will automatically return to and
display the chosen mode.
Electronic clock
The screen of audio system usually displays
time when the ignition switch is on the
ACCESSORY or ON.
To set up time, press AUDIO (CLOCK) for
2 second, after hearing reminding sound, it
enters clock adjusting mode. Then hold
the H (preset 4) of the bar until the hour
number increases to the desired hour；hold
M (presetting 5) until the minute number
increases to desired minute.
Use the R (presetting 6), of the bar to set the
time to the starting point of the nearest hour
quickly. At the clock adjusting mode, press
the R. If the time is the former half hour,
press R to enact the time always to former
one hour... If the time is rear half hour, press
R to enact the time to the beginning of
next hour.
For example：
1:06 will be enacted to 1:00