User's Manual

22
WIRELESS 5-IN-1 SENSOR MAINTENANCE
REPLACE THE WIND VANE
Unscrew and remove the wind
vane for replacement
REPLACE THE WIND CUP
1.
Unscrew and remove the
top cap
2. Remove the wind cup for
replacement
CLEANING THE RAIN COLLECTOR
1. Rotate the rain collector by turning
it 30°anti-clockwise.
2. Gently remove the rain collector.
3.Clean and remove any debris or
insects.
4.Install the collector when it is clean
and fully dried.
CLEANING HYGRO-THERMO
SENSOR
1. Remove the 2 screws at the
bottom of the radiation shield.
2. Gently pull out the shield.
3. Carefully remove any dirt or
insects on the sensor and
ventilation fan (do not let the
sensors inside get wet).
4.Clean the shield with water to
remove any dirt or insects.
5.Install all the parts back when
they are clean and fully dried.
TROUBLESHOOT
Problems Solution
5-In-1 wireless sensor
is intermittent or no
connection
1. Make sure the sensor is within the transmission range
2. If it still not work, reset the sensor and resynchronize with
console.
Wireless thermo-hygro
sensor is intermittent or no
connection
1. Make sure the sensor is within the transmission range
2. Make sure the channel displayed match to the channel selection
on sensor
3. If it still not work, reset the sensor and resynchronize with
console.
No WI-FI connection 1. Check for WI-FI symbol on the display, it should be alway on.
2. Make sure you connect to 2.4G band but not 5G band of your
WI-FI router.
Data not reporting to
Wunderground.com or
weathercloud.net
1. Ensure your Station ID and Station Key are correct.
2. Ensure the date and time is correct on the tablet . If incorrect,
you may be reporting old data, not real time data.
3. Ensure your time zone is set properly. If incorrect, you may be
reporting old data, not real time data.
Wunderground Precip.
Accum. Total graph o󰀨set
1 hour reset time, during
summer daylight saving
time
1. Ensure the time zone of the device on Wunderground set
correctly
2. Ensure the time zone and DST on your console are correct.
3. If you located your station out of US time zone region in
Wunderground, the DST will be invalid. To solve this issue,
please turn o󰀨 the DST function in console.
Rainfall is not correct 1. Please keep the rain collector clean
2. Make sure the tipping bucket inside can work smoothly
Temperature reading too
high in the day time
1. Place the sensor in open area and at least 1.5m o󰀨 the ground.
2. Make certain that the sensor array is not too close to heat
generating sources or strictures, such as buildings, pavement,
walls or air conditioning units.