User's Manual

24
MAINTENANCE
BATTERY REPLACEMENT
When low battery indicator “ ” is displayed
in OUT or CH section, it indicates that the
outdoor 7-IN-1 sensor and current channel
sensor battery power is low respectively.
Please replace with new batteries.
WIRELESS 7-IN-1 SENSOR MAINTENANCE
REPLACE THE WIND VANE
Unscrew and remove the wind
vane for replacement
REPLACE THE WIND CUP
1.
Unscrew and remove the
top cap
2. Remove the wind cup for
replacement
CLEANING THE RAIN COLLECTOR
1. Rotate the rain collector by turning
it 30°anti-clockwise.
2. Gently remove the rain collector.
3.Clean and remove any debris or
insects.
4.Install the collector when it is clean
and fully dried.
CLEANING THE UV SENSOR AND
CALIBRATION
• For precision UV measurement,
gentle clean the UV sensor cover
• Over time, the UV sensor will
naturally degrade. The UV sensor
can be calibrated with a utility
grade UV meter, please refer to
Calibration section in previous
page for about the UV sensor
cablibration.
CLEANING HYGRO-THERMO
SENSOR
1. Remove the 2 screws at the
bottom of the radiation shield.
2. Gently pull out the shield.
3. Carefully remove any dirt or
insects on the sensor and
ventilation fan (do not let the
sensors inside get wet).
4.Clean the shield with water to
remove any dirt or insects.
5.Install all the parts back when
they are clean and fully dried.
TROUBLESHOOT
Problems Solution
7-in-1 wireless sensor
is intermittent or no
connection
1. Make sure the sensor is within the transmission range
2. If it still not work, reset the sensor and resynchronize with
console.
Indoor wireless sensor
is intermittent or no
connection
1. Make sure the sensor is within the transmission range
2. Make sure the channel displayed match to the channel
selection on sensor
3. If it still not work, reset the sensor and resynchronize with
console.
No WiFi connection
1. Check for WiFi symbol on the display, it should be alway
on.
2. Make sure you connect to 2.4G band but not 5G band of
your WiFi router.