Instructions / Assembly

GND

ASSEMBLY AND INSTALLATION INSTRUCTIONS

WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER

WHILE INSTALLING OR SERVICING THIS FIXTURE

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

1. Attach the mounting plate to the outlet box by using two mounting screws.

2. Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow:

---Connect the hot wire(usually black insulation)from the fixture to the black wire from the power source.

---Connect the neutral wire(usually white insulation)from the fixture to the white wire from the power source.

---Attach the fixture grounding wire(usually green insulation or bare wire)to the mounting strap with the green

grounding screw.Then connect it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

3. Attach the back plate to the mounting plate by inserting the screws,then secure it with two nuts.

CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the

wall surface to prevent water from seeping into the outlet box.

Turn on the power at fuse or circuit box.

CA2175-W

Decorative Nuts

Bulb (Not included)

To work properly.you

should install this

fixture NOT confront any

jets of air conditions

or strong airflow

Outlet Box

White Wire

Live Wire

Negative Wire

Ground Wire

Black Wire

Machine Screw

CAULK

PAGE 1
ASSEMBLY AND INSTALLATI CA2175-W WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE NOTES: 1. Before installing, consult local electrical codes for wiring and g 2. READ AND SAVE THESE INSTRUCTIONS. K Ground Wire UL A C Machine Screw Black Wire To work properly.you should install this fixture NOT confront any jets of air conditions Outlet Box or strong airflow Negative Wire Live Wire GN D White Wire Decorative Nuts Bulb (Not included) 1.
PAGE 2
Function and Operation MODES OF OPERATION Mode Stand-by mode Test mode Works at Day & Night Day & Night Auto mode Night only Manual override mode Night only Shut off ON time / 20 Sec As motion existing As motion existing 5 Sec 2 Min. Manual 8Hrs or override Turn off at operate dawn Low Brightness Operating Diagram Turn wall switch OFF-ONOFF-ON within 0.5~2sec. Start Cancel FIG.1 low brightness Turn wall switch OFF-ONOFF-ON within 0.5~2sec.
PAGE 3
NOTE: 1. The sensitivity of the motion sensor will increase as the 2 of 3 environmental temperature gets cooler. For best performance, gently clean the lens with a soft cloth every 1 or 2 months to assure maximum sensitivity. 2. For best performance, install fixture at least 6 feet above The ground. At such a height, the lantern will provide a detection distance of up to 40 feet at 77 degrees Fahrenheit.(See Fig.2) 3. The sensor detects across a detection range of 220 degrees.(See Fig.3) 4.