Instructions / Assembly

INSTALLATION & ASSEMBLEY
Remove the fixture and the mounting package from the box and make
sure that no parts are missing by referencing the illustrations on the
installation instructions.
1. Place the mounting wall plate(3) over the outlet box(1), align
themounting slots of the wall plate with holes of the outlet box as
shown. Use a level to ensure the wall plate(3) is straight.
2. Mark the loca
tion of the keyhole slots of the wall plate on the wall.
Drill a ¼” holes at the narrow end of each keyhole slot marking on the
wall. Carefully hammer a wall anchor into each drilled hole.
3. Pull the supply wires (4 &5) and house ground wire (6) out from the
outlet box (1) before attaching wall plate to outlet box.Make electrical
connections, connect the blac
k fixture wire (9) to the black supply wire (5)
and contect the white fixture wire (10) to the white supply wire (4) by
using wire nut (7). Connect the fixture ground wire (10) to the supply
ground wire (6) together by using wire nut (7). Wrap all wire connections
with electrical tape to ensure secure connection.
4. Place the fixture body (11) over the mounting wall plate (2) and secure it
to the wal
l plate by using rubber shim(12), stainless steel shim(13) and
fixture screws (14) .
5. After installing the fixture, caulk upper 2/3 of wire connection enclosure
to mounting surface. Leave bottom 1/3 un-caulked for drainage of any
water that might leak into the enclosure. The manufacturer recommends
a non-drying exterior caulking material. A good example is a clear silicone
rubber sealant fo
r exterior use.
1.OUTLET BOX (EXCLUDED)
2. MOUNTING WALL PLATE
3. MOUNTING SCREWS
4. WHITE SUPPLY WIRE
5. BLACK SUPPLY WIRE
6. SUPPLY GROUND WIRE
7. WIRE NUTS
Turn off the main power at the circuit breaker before installing and servicing
the fixture to prevent possible injury from electric shock.
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical
wiring connections, obtain the services of a qualified electrician.
INSTALLATION INSTRUCTIONS
LED OUTDOOR
WALL SCONCE 120VAC Input, Dimmable
READ AND FILLOW SAFETY INFORMATION
8. WHITE FIXTURE WIRE
9. BLACK FIXTURE WIRE
10. FIXTURE GROUND WIRE
11. FIXTURE BODY
12. RUBBER SHIM
13. STAINLESS STEEL SHIM
14. FIXTURE SCREWS
6. Installation complete, restore power at the circuit breaker and turn
light switch on to activate this fixture.
Care and maintenance – Use dry and clean cloth to wipe the surface of the
fixture.
Replacement- This LED
product has no bulb to replace.