Instructions / Assembly

GND

Mounting Plate

Box Screws

Mounting Screws

Wire Caps

Outlet Box

(not included)

Box Screw

Green Grounding

Screw Marked GND

Bulb (Not included)

Decorative Nuts

Rubber Washers

3.Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts,as follow:

---Connect the hot wire(usually black insulation)from the fixture to the black wire from the power source.

---Connect the neutral wire(usually white insulation)from the fixture to the white wire from the power source.

---Attach the fixture grounding wire(usually green insulation or bare wire)to the mounting strap with the green

grounding screw.Then connect it to the house grounding wire with the wire nut.Carefully put the wires back into

the outlet box.

4.Attach the back plate to the mounting plate by inserting the screws,then secure it with two screw.

CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall

surface to prevent water from seeping into the outlet box.

Turn on the power at fuse or circuit box.

1.As shown, fix the Iron Hook with two Install screws, then Install the bent metal bar and fix it with

Install screws.

2.Attach the mounting plate to the outlet box by using two mounting screws.

Bent Metal Strip

CA2342-W

ASSEMBLY AND INSTALLATION INSTRUCTIONS

WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE

NOTES: 1. Before installing, consult local electrical codes for wiring and

grounding requirements.

2. read and save these instructions.

Iron Hook

Install screws

Rubber Washers