Product Specs

Integrator is reminded to assure that these installation instructions will not be made available to the
end-user of the final host device.
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label
stating the FCC ID of the RF Module, such as "Contains FCC ID: OMCBTAUD3
"This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired
operation."
"Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment."
the Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the module integrated
into the host device.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label
stating the IC of the RF Module, such as" Contains transmitter module IC: 3673A-BTAUD3
Le périphérique hôte final, dans lequel ce module RF est intégré "doit être étiqueté avec une étiquette
auxiliaire indiquant le CI du module RF, tel que" Contient le module émetteur IC: 3673A-BTAUD3
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'
en compromettre le fonctionnement.
Radio Frequency Exposure Statement for IC
The device has been evaluated to meet general RF exposure requirements. The device can be used in
mobile exposure conditions. The min separation distance is 20cm.