INSTRUCTION MANUAL PLEASE READ ALL THE INSTRUCTIONS COMPLETELY BEFORE USE AND SAVE THIS MANUAL FOR FUTURE REFERENCE Revision 2 - 3/25/13
Introduction/ Safety Instructions Introduction The CC Pocket radio uses the latest in digital chip technology along with our own techniques developed at C. Crane. It is able to bring in a weak FM station better than perhaps any other pocket radio. The button layout is easy to understand for basic use. It is different than other radios because some of the features can be changed by reading the manual and using multiple button presses to change them.
Table of Contents Installing the Batteries..................................................................4 Display Screen Identification.......................................................5 Powering the Radio......................................................................6 Setting the Sleeptimer..................................................................6 Listening with Earphones.............................................................6 Earphones as FM Antenna..........................
Getting Started INSTALLING THE BATTERIES 1) Position the radio face down on a soft surface to protect it. 2) Remove the battery cover using your fingernail or small tool. Press and lift the area indicated below. 3) Insert the two (2) “AA” cell batteries into the compartment as indicated. Be sure the negative (-) end of each battery is against the spring. 4) Replace the battery cover. You are now ready to operate your radio.
Radio Identification DISPLAY SCREEN A. B. C. D. E. F. G. H. I. J. K. L.
Radio Identification 1. Power button / Sleep Timer To turn the radio “ON” just press the red button. To use the Sleep Timer, press and hold the red button. The Sleep Timer will automatically shut off the radio after the set amount of time expires. The display will cycle through minutes 90, 60, 30, 15, 120, and OFF. Release the power button to activate the sleep setting you desire. The radio will remember your last Sleep Timer setting the next time you use it. 2.
Radio Identification 7. Change Bands and Memory Pages Press and release the BAND button to cycle between FM, AM, and Weather. The BAND button can also be used to access station memory pages. This gives you 20 additional presets for AM and FM. Press and hold the BAND button for 2 seconds to change page numbers, press any memory button 1-5 to select the Page number that you desire. Each page can hold five additional station memories. 8.
Radio Identification 10. Earphone / Speaker Switch Stereo (Top Position) – This position is for listening to FM Stereo radio using headphones. While in this position, the speaker will be disabled. AM and WX bands will play normally. Mono (Middle Position) – This position is for listening to FM Mono radio using headphones. Typically, FM Mono will have better reception than FM Stereo. Speaker (Bottom Position) – This position is for listening to AM, FM, or WX using the speaker.
Radio Setup Setting the Clock 1. With the power OFF, press and hold memory button #1 for two seconds. 2. While the Hour is flashing, press the Up or Down Tuning buttons until the hour and AM/PM time is correct. 3. Press memory button #1 again to adjust the minutes. Cycle minutes using the Up or Down tuning buttons. 4. Press memory button #1 again after time is set correctly. Setting the Alarm 1. With the power OFF, press and hold memory button #2 for two seconds. 2.
Radio Setup Disable Beep Sound 1. With the power OFF, press and hold memory button #3 for two seconds. All beeps are disabled except ALARM and WX ALERT. 2. Repeat sequence to enable beep again. Designate Frequency or Clock while Listening to the Radio 1. With the power OFF, press and hold memory button #4 for two seconds. “C” will appear on the screen to indicating that the Clock will show while listening to radio. 2. Repeat sequence to display Frequency instead.
Radio Setup Activate 9 or 10 kHz AM Tuning (also expands FM band) 1. With the power OFF, press and hold memory button #5 for two seconds to activate 9 kHz AM tuning mode. This will also expand the FM band from 76 MHz to 108 MHz. 2. Repeat sequence to switch back to 10 kHz AM tuning and regular FM coverage. Disable Display Screen Quickly press memory buttons #1 and #5 at the same time while listening to your desired AM station. NOTE: This is used to improve AM radio reception.
Troubleshooting Guide The CC Pocket will not turn on and none of the buttons work: The Lock Switch, located on the right side of the radio under the ALERT button, is in the up position. Push the switch down to release the lock and resume normal operation of the radio. (Please see Lock Switch on page 7.) My radio shuts off after just a few seconds: Low batteries can cause this situation. Replace them with a new set of batteries. Stations won’t hold in memory: The memory button settings are being overwritten.
Specifications FM Band: 87.5 - 108 MHz (Regular Mode) FM Band: 76 – 108 MHz (Expanded Mode – See page 11) AM Band: 520 - 1710 kHz Weather Band: Channel 1: 162.400 MHz Channel 2: 162.425 MHz Channel 3: 162.450 MHz Channel 4: 162.475 MHz Channel 5: 162.500 MHz Channel 6: 162.525 MHz Channel 7: 162.550 MHz POWER SOURCE Batteries: (2) “AA” size POWER CONSUMPTION 30 -100 mA DC (depending on headphone or speaker usage) AUDIO Speaker: 1.25", 8 Ohm, 0.
Model: CCPocket FCC ID: ATE20122228 THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS. 1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Notice: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Copyright © 2013 by C. Crane Company, Inc.