User Manual

Edition 09/2000
2
Technical specifications
Input voltage 12 V AC or DC
Outputs 3 relay outputs, N/O & N/C contact 8A/250V~
Users 800 badges (proximity and RF Transmitter)
Master badge 1 programmable proximity badge
Memory Capability to transfer copy all data on a other control unit
RF receiver Built-in RF receiver on the control unit
Inputs 2 Request-to-exit inputs
Présentation 3-digit 7 segments display
4 programming keys
Distance between the
readers and the control
unit
minimum 60 cm,
maximum 50 m
(recommended cable 7 x 0.6 mm
2
)
Default values
Master Badge: Not programmed
Relay time delay: 1 second
Programming delay: 120 seconds (2 minutes)
Push buttons
The request-to-exit button activates relay RL1 and RL2 independently (the relay can be programmed in
momentary or latched time output).
Programming keys
PROG key (red button)
The PROG key allows you to enter and to exit from programming. Press twice on the button to exit from
programming: Press once to exit from a menu and go back to the main menu, Press a second time to exit from
the main menu and go back to a normal mode.
Nxt and Prv buttons (yellow buttons)
The Nxt and Prv keys are used to scroll in the main menu, to go back and forth to any menu.
Fast scrolling with Nxt and Prv keys
Keep the button depressed to move faster in one of the menu, especially when you selecting a user number or a
time delay.
Enter button (green button)
Press the Enter key for selecting a menu and also to save the new data.
To delete a data press twice on the Enter button.
Note: Do not use a switching power supply with the UCA3 control unit