User Manual

Edition 09/2000
8
The following message is displayed on the Control Unit which transmit the data
On the other Control unit the message is displayed.
Press Ent button start the transmission.
Once the transfer is completed this message appears on the two Control Units during 5
seconds.
Connection ERROR between control units
If the two Control Unit are not connected properly an error message is displayed
Verify the wiring and try again.
Setting the Master Badge (menu 4)
L’affichage indique si un badge maître est déjà programmé ou pas.
Master Badge not programmed Master Badge programmed
Present a badge in front of the proximity reader and Press twice Ent button to delete the Badge
press Ent to save the new Master Badge.
The display becomes the display changes to
Master Badge Programmed Present a new Master Badge.
Press PROG button to go back to the main menu.