User Manual

Edition 09/2000
9
Badge and RF Transmitter Identification (Menu 5)
The display is off. The 5
th
LED is on.
Present the badge in front of the Control Unit proximity reader or press on one the button of the RF
Transmitter.
The display indicates the badge is identified as 271 as the user number. This badge is
Authorised on door 1 only the dot is next to digit 2
When the display indicates an RF Transmitter is programmed on door 3 with a user number
702
It is not necessary to go out from the identification Menu for identifying more than one badge.
The user number is not displayed if the badge or RF Transmitter is not programmed in the control unit.
The following message is displayed when the control unit identifies the master badge.
The master badge is authorised on door 1 and 2.
This message is displayed when a badge or RF Transmitter is invalid.
To exit from the identification Menu press the PROG button. Press a second time to exit from the
programming mode.
Antenna
It is possible to connect an antenna of 50 Ω to the terminal block 25 and 26.
Door 1 Door 2 Door 3 - ------------------------------Door number
??