Service Tool Instruction Manual

II0049CPage 1 of 1
600/700/800 Service Tools
General Instructions
C. E. Niehoff & Co
.
BRUSHLESS ALTERNATORS
C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline [phone]
The tools shown below should be used as indicated in the applicable service manuals for CEN 600, 700, and
800 Series Alternators. If you have any questions, contact the CEN Technical Service Department.
This tool is used to remove the field coil, insert the field coil, and remove the stators.
Tool part numbers:
CEN A10–128—800 series
CEN A10–132—600 & 700 series
Removing/
inserting field coil
Removing stators
(crossbar not
needed)
CEN A10–131 tool
is used to remove
the anti-drive end
(ADE) housing from
C802 and C704
alternators.
This tool is used to remove the
drive end (DE) housing from
C802 and C704 alternators.
Tool part number:
CEN A10–134—800 series
CEN A10–133—600 & 700 series
This tool is used to install stators.
Tool part numbers:
CEN A10–137—
800 series (includes 6 insertion studs A9-846).
CEN A10–136—
600/700 series (includes 6 insertion studs A9-814).
CEN A10–130 tool is
used to separate field
coil connectors.
CEN A10–135 tool is
used to install pulleys.
*Insertion studs must be removed after stators are installed.
DO NOT USE INSERTION STUDS in final assembly.