Specifications

C-giant rel 3.07. Sales by Jemba, Sweden. Tel [phone]
C-giant Page 15
5. OPERATION
5.1. Distances measurement (Trip l, Trip 2 and Trip 3)
When measuring distances C-giant has got three registers for this purpose, TRIP l,
TRIP 2 and TRIP 3. They may be used individually with separate counting directions
plus (+) or minus (-). 'HALT' will stop the current register. 'SPLIT' freezes the values
of all registers. If the measurement is to be done in the negative direction you just
press the (-) key. If the yellow cable is connected to the reverse light the trip meters
automatically switch counting direction when the vehicle is going in reverse.
5.1.1. Pre-set.
If you want to start measuring from a point at a known distance it is easy to set that
value into a trip register. Select the trip to be used (TRIP l, TRIP 2 or TRIP 3), press
the SET button and feed the value into the register with the numeric keys O - 9. The
input is confirmed with the SET key. Now your measuring starts from the set distance.
If you require the measurement to start from a negative value the figures must be
preceded by a minus sign. If you change your mind it is possible to get the original
value by pressing RESET instead of SET.
5.1.2. Align trip to road book
The registers may also be adjusted with an arbitrary value. See section SET. If a
junction is passed at 43.67 km according to the road book but the trip shows a different
value then it is easy to adjust the trip very accurately without stopping the car. Reset
the trip at the junction. Carry on driving and press SET and input the desired value
(43670) with the numeric keys. Finish the input with (ADD/-). When you terminate
the input with the (ADD/-) key that means that the current value is to be adjusted with
the input value. The result is that the measurement takes place from the junction with
the correct value.
RESETOPTION
CAL
SPLIT
89
HALT
7
BREAK
ADD
0
PILOT
6
FUEL
5
TIME
4
TRIP1 TRIP2
12
SPEED
3
SET
by Coralba Sweden
.
.
.
-giant
5.1.3. Memory register
Second touch of TRIP 1 will select a memory register. It is possible to set, add and
subtract values in decimal format. RESET' will set the display OFF. This is the only
way to get a C-giant or C-view blank when driving. This blank window may be copied
into all windows with the arrow keys.